Home / Professional Products / Professional Microphones / Drum Mounting System - ATM350D

Drum Mounting System

ATM350D
  • Low-profile design for minimum visibility.
  • Crisp, clear, well-balanced microphone response, even at high SPLs
  • Cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source
  • UniMount® drum mount with unique spring-loaded mechanism attaches securely to a drum lug, and provides excellent shock resistance for the microphone
  • Rugged UniMount® 5" gooseneck rigidly holds its shape, keeping microphone accurately positioned even during aggressive play
  • In-line power module is equipped with a switchable 80 Hz high-pass filter to control undesired ambient noise
  • Interchangeable elements available for hypercardioid and omnidirectional polar patterns
  • Included violin mount with hook-and-loop fastener provides an additional mounting option

    The ATM350D Drum Mounting System is designed to stand up to powerful drumming. The spring-loaded mount clamps onto a tension rod (without hindering your ability to adjust the tension) and provides excellent shock resistance for the mic. The sturdiness of the 5" gooseneck ensures that the mic will stay where you set it and won’t bounce around, no matter how hard you play.

    • ATM350D Specifications

    Element

    Fixed-change back plate permanently polarized condenser
    Polar Pattern

    Cardioid
    Frequency Response

    40 ~ 20,000 Hz
    Low Frequency Roll-Off

    80 Hz, 12 dB/octave
    Open Circuit Sensitivity

    -49 dB (3.5 mV) re 1V at 1 Pa
    Impedance

    200 Ω
    Maximum Input Sound Level

    159 dB SPL, 1 kHz at 1% T.H.D.
    Dynamic Range (Typical)

    130 dB, 1 kHz at Max SPL
    Signal-To-Noise Ratio

    65 dB, 1 kHz at 1 Pa
    Phantom Power

    11-52V DC, 3.5 mA typical
    Switch

    Flat, roll-off
    Weight

    MICROPHONE : 14.5 g;
    POWER MODULE : 90 g
    Dimensions

    MICROPHONE - 37.8 mm - long, 12.2 mm - diameter POWER MODULE - 92 mm - long, 18.9 mm - diameter
    Output Connector

    Integral 3-pin XLRM-type
    Cable

    4.0 m long (permanently attached to microphone), 3.2 mm diameter, 2-conductor shielded cable with HIROSE HR10-type connector
    Accessories Furnished

    AT8543 power module; AT8491D Uni-Mount® drum mount; AT8490 5-inch gooseneck; AT8468 violin mount; protective carrying case

    Download

    audio technica support ATM350a_Manual.pdf - User Manual
    audio technica support ATM350a_brochure-en.pdf - Produce Brochure (Eng)
    audio technica support ATM350a_Brochure-cs.pdf - Produce Brochure (Chinese)
    • Social